Press ESC to close

Mahmut YUMMahmut YUM Kişisel Blog

How to Quickly Add Multiple IP Addresses to Windows Servers

If you have ever added multiple IP addresses to a single Windows server, going through the graphical interface is an incredible pain as each IP must be added manually, each in a new dialog box. Here’s a simple solution.

image

Needless to say, this can be incredibly monotonous and time consuming if you are adding more than a few IP addresses. Thankfully, there is a much easier way which allows you to add an entire subnet (or more) in seconds.

Adding an IP Address from the Command Line

Windows includes the “netsh” command which allows you to configure just about any aspect of your network connections. If you view the accepted parameters using “netsh /?” you will be presented with a list of commands each which have their own list of commands (and so on). For the purpose of adding IP addresses, we are interested in this string of parameters:

netsh interface ipv4 add address

Note: For Windows Server 2003/XP and earlier, “ipv4″ should be replaced with just “ip” in the netsh command.

If you view the help information, you can see the full list of accepted parameters but for the most part what you will be interested in is something like this:

netsh interface ipv4 add address “Local Area Connection” 192.168.1.2 255.255.255.0

The above command adds the IP Address 192.168.1.2 (with Subnet Mask 255.255.255.0) to the connection titled “Local Area Network”.

Adding Multiple IP Addresses at Once

When we accompany a netsh command with the FOR /L loop, we can quickly add multiple IP addresses. The syntax for the FOR /L loop looks like this:

FOR /L %variable IN (start,step,end) DO command

So we could easily add every IP address from an entire subnet using this command:

FOR /L %A IN (0,1,255) DO netsh interface ipv4 add address “Local Area Connection” 192.168.1.%A 255.255.255.0

This command takes about 20 seconds to run, where adding the same number of IP addresses manually would take significantly longer.

A Quick Demonstration

Here is the initial configuration on our network adapter:

ipconfig /all

image

Now run netsh from within a FOR /L loop to add IP’s 192.168.1.10-20 to this adapter:

FOR /L %A IN (10,1,20) DO netsh interface ipv4 add address “Local Area Connection” 192.168.1.%A 255.255.255.0

After the above command is run, viewing the IP Configuration of the adapter now shows:

image

Mahmut YUM

Lise yıllarında kendi sitesini kurarak Webmaster, Server Manager ve en son olarak Network dünyasının içinde kendi bulmuş bir insan parçası. Hepsi hayal de olabilir.